cannot select 2010 in configure.exe

Questions and postings pertaining to the development of ImageMagick, feature enhancements, and ImageMagick internals. ImageMagick source code and algorithms are discussed here. Usage questions which are too arcane for the normal user list should also be posted here.
Post Reply
graemeNPS
Posts: 64
Joined: 2009-01-12T14:25:55-07:00

cannot select 2010 in configure.exe

Post by graemeNPS »

I have downloaded the 6.9.3.1 source. When I run the configure.exe, there is no option for visual studio 2010. I have a lot of stuff that uses vs2010. Is there any quick way to convert all the projects to vs2010, and, if I do, will the linkage to the installed version (ImageMagick-6.9.3-1-Q16-x86-dll.exe) be OK?
We build the source in Q16, and then run against an installed version's dll.
This all worked with 6.9.0.7 and ImageMagick-6.9.0-7-Q16-x86-dll.exe
User avatar
dlemstra
Posts: 1570
Joined: 2013-05-04T15:28:54-07:00
Authentication code: 6789
Contact:

Re: cannot select 2010 in configure.exe

Post by dlemstra »

You should give the tiny scrollbar on the right side in the dropdown a try :)
.NET + ImageMagick = Magick.NET https://github.com/dlemstra/Magick.NET, @MagickNET, Donate
graemeNPS
Posts: 64
Joined: 2009-01-12T14:25:55-07:00

Re: cannot select 2010 in configure.exe

Post by graemeNPS »

Thanks. I really did not see the scrollbar. Seems the older I get, the dumber I get. I hope to have a brain cell left in a year or two.

g
User avatar
dlemstra
Posts: 1570
Joined: 2013-05-04T15:28:54-07:00
Authentication code: 6789
Contact:

Re: cannot select 2010 in configure.exe

Post by dlemstra »

No worries, I also had to look for it :)
.NET + ImageMagick = Magick.NET https://github.com/dlemstra/Magick.NET, @MagickNET, Donate
Post Reply